Remanufacturing is the process of revitalizing old machinery and equipment. It takes old machine equipment as blank, adopts special craft and technology, a new manufacture is carried out on the basis of the original manufacturer, and the remanufactured products are as good as the original ones in both performance and quality.
Scientifically speaking, remanufacturing is an industry that carries out high technology repair and transformation on waste products, and it targets the parts that are damaged or will be scrapped, based on the analysis of performance failure and life evaluation, the design of remanufacturing engineering is carried out, adopt a series of related advanced manufacturing technology to make the quality of remanufactured cement concrete mixer truck meet or exceed the old cement mixer for sale.
The process of remanufacturing the mixer truck used of Hunan Teila Heavy Industry Machinery Service Co., Ltd is below: Check and maintain the engine properly, gearbox maintenance ensure there is no noise when putting into gear. Maintenance inspection for the middle and rear axle. Reducer inspection and maintenance and checking no oil leakage point on the main oil pump. Check clutch, main pump, booster pump, clutch plate, and braking system thoroughly. Inspection for brake master cylinder, brake cylinder, brake pad. Clean up the oil lines and diesel tank to replace the filter. Light check and line arrangement make sure all the lights are on. Air pressure and air circuit system check to ensure no air leakage. Air conditioner maintenance. Internal appearance trimming, the cement of mixer tank is cleaned. Inlet and outlet, Herringbone slot, stairs on both sides repair welding. Roller track bearing inspection without abnormal noise. Control rod wiredrawing replacement repair. The vehicle tire, changing the vehicle and beat the butter and cab beauty.
Comments