If the time of hf welding pvc is too long, there are often some faults. After the failure occurs, users must find and deal with it in the first time and solve it in time. For different faults, the solutions are different. The following solutions are listed here for everyone:
If the welding effect is not ideal or it cannot be welded or the workpiece is damaged when it is in the process of hf welding pvc, we can not think that it is the problem of equipment. It could be other problems. For example: equipment setting error, blown fuse and so on may happen.
Common failure analysis and solutions:
- If there are bubbles in the process of hf welding pvc with workpieces, it is not directly related to the equipment usually.
(1) situation of loose connection
it is possible that the flow meter of the gas regulator has been damaged or blocked with sundries.
(2) there may be sundries on the surface of the workpiece.
- it is not directly related to the equipment if the voltage is unsteady in the process of hf weldingpvc with workpieces.
(1) loose connection wire between the main machine and the extension machine
(2) the induction coil is out of shape or there is no distance between the coil and the coil, or the induction coil is loose.
If above circumstance has been excluded, it still cannot work normally, users should turn off equipment and ask professional technicians to repair the equipment. If the device suddenly stops working in the process of use, you should immediately turn off the device and check the host, and wait for 3-5 minutes before starting up. If it can not work normally after turn it on, ask professional technicians to repair the equipment. But users also need to be skilled in using the equipment, and can make an accurate judgment of the corresponding fault to timely solve the fault, reduce the waste and loss of equipment and production.
