Application Field: Works With
Gear Ratio: 61:1 | Output Torque: 6.5KN.m |
Tilting Moment Torque: 21.3KN.m | Holding Torque: 36KN.m |
Static Axial Rating: 415.7KN | Static Radial Rating: 135KN |
Dynamic Axial Rating: 81KN | Dynamic Radial Rating: 71KN |
Precision: ≤0.15° | Weight: 55KG |
The Single-Row Ball type Slewing Ring have four points with one row. They could bear axial load, radial load and tilting moment at the same time. And they are composed of two seat rings, which design in compact structure and light weight, steel ball contact with the circular raceway at four points. There are three types of this kind of single row 4 points contact ball slewing bearing: without gear bearing (non tooth), external crane slewing gear bearing (external tooth), and Internal gear bearing (internal tooth).
Cleverly Change the Lower Bearing of the Tower Crane Slewing
Cleverly change the lower bearing of the tower crane slewing:
- Firstly, the main rope of the tower crane will be replayed.
- At 13cm on the flange connected to the bearing seat at the olive-shaped bottom of the rotating body, use a 14mm diameter steel bar to pull the ribs on the four sides of the tower machine in the horizontal direction.
- At the top four corners of the crane slewing ringplatform, each line has a wire rope buckle with a diameter of 12.5mm, each hanging a 4 ton chain hoist.
- The four hoist hooks are hung on the angle steel at the lower part of the revolving body at 90 cm. Be sure to hang it up. If there is no hanging point, you can weld a ring with electric welding.
- After tightening the hoist slightly, remove the connecting bolts of the flange and the bearing seat, the bearing seat and the tower body.
- Tighten the hoist to create a gap between the parts.
- Quickly pull out the bearing housing and immediately insert the corresponding thick square wood prepared in advance for the position of the housing that is pulled out.
- Replace the new tapered tower crane slewing bearingwith the bearing model and add enough butter.
- Reinstall the parts in place according to the above steps.
- After removing the temporary fixed steel bars and other objects, they can be tested and put into use.
Slew drive can also be called slew drive gearbox. Most of our slewing ring drive is kind of worm gear reducer. And the slew ring bearing is a gear drive part.
The slewing drive is a full-cycle rotary reduction transmission mechanism integrated with a driving power source. As a professional slew drive manufacturer, Fuyong Intelligent produces high-quality slewing ring drive products! Any inquiry is welcome!
Comments